In the case of including electric induction, a reverse induced voltage will be generated. The higher the voltage, the greater the energy, and the contact consumption and migration will also increase. Therefore, it is necessary to confirm the rated conditions, and the control capacity is marked in the rated value, These alone are not enough. In special load circuits such as voltage, current waveform, load type, etc., when they are turned on and off, the actual equipment must be tested and confirmed separately. For small voltages and currents, use products for small loads. When using general-purpose silver contacts, contact reliability may be reduced.
If the push-button switch exceeds the range of the push-button switch in the miniature and high-load type, connect a relay suitable for the load.